Prepare the vials

• Ensure that product and diluent vial flip caps are removed and the stoppers are treated with an aseptic solution and allowed to dry prior to opening the Mix2Vial package.

Blue for the water

Place on a hard flat surface

• Open the Mix2Vial package by peeling away the lid, then hold the vial tight. Take the Mix2Vial together with the package and push the blue end straight down through the diluent stopper.

Pull off the package

Place on a hard flat surface

• Carefully remove the package from the Mix2Vial set. Make sure that you only pull up the package and not the Mix2Vial set.

Invert the diluent vial

Place on a hard flat surface

• Invert the diluent vial with the Mix2Vial set attached and push the transparent adapter straight down through the product vial stopper. The diluent will automatically flow into the product vial.

Unscrew the set

Place on a hard flat surface

• With one hand hold the product-side of the Mix2Vial set, hold the diluent-side with the other hand and unscrew the set into two pieces.
• Discard the diluent vial with the blue part attached.

Gently swirl

• Gently swirl the product vial until the product is fully dissolved.
  Do not shake.

Load the syringe

• Draw air into an empty, sterile syringe. While the product vial is upright, connect the syringe to the Mix2Vial’s Luer Lock fitting. Inject air into the product vial.

Load the syringe

• While keeping the syringe plunger pressed, invert the system upside down and draw the concentrate into the syringe by pulling the plunger back slowly.

Load the syringe

• Now that the concentrate has been transferred into the syringe, firmly hold on to the barrel of the syringe (keeping the syringe plunger facing down) and disconnect the Mix2Vial set from the syringe.